Stuff a small about in the end of the pipe Put the rock on this and melt it into the wire wool/Brillo pad Then you have a surface that you can heat in order to keep the crack in one place. Apply direct heat to the wire wool, through the glass works fine, it will start to smoke. Apr 28, 2005 If you're curious about as to how a crack pipe is made I offer the following for your information: Materials: 1.) Hollow glass tube (available at your local liquor store) Edited, September 10, 2005 Since I wrote this almost two years ago, state and federal law enforcement agencies have come down hard on places that sell glass tubes.
- Can You Smoke Crack With A Glass Pipe? - Quora
- Answered - - How To Smoke Crack And Not Waste It | Drugs-Forum
All right, cannabis adventurers, today’s tip is a bit of a “how-to”! If like many cannabis consumers you’re using a custom-made glass pipe, you’ve likely noted that keeping that pipe looking as sparkly-clean, attractive—and functional—as the day you purchased it, is a wee bit harder than you may have expected.
The unctuous black resin that results from smoking cannabis is quite apt to stain clothing, your hands, and anything else it comes in contact with. Fortunately, maintenance of glass is hardly rocket science; it just takes patience, the right tools, and a little bit of advanced planning. Pioneer m-22.
How to Clean Glass Pipe – Start Smart
What You’ll Need to Clean Your Glass Cannabis Pipe
First of all, let’s lay out the materials you’ll want to have close at hand before cleaning:
- A bobby pin or other thin wire implement
- Paper towels, tissue or expendable rag
- Sealable plastic freezer baggie
- Salt, preferably coarse or kosher
- Isopropyl (rubbing) alcohol, 90% or higher
- Pipe cleaner (available at craft stores or well-stocked drug stores and dispensaries)
How to Clean Glass Pipe In 4 Easy Steps:
Step 1: Soften the resin by applying heat. One of the easiest ways, naturally, is to use the pipe for its intended purpose, just so long as you feel that imbibing won’t muddle the cleaning process!
Step 2: Using the bobby pin or similar device, gently scrape the resin from the bowl, walls, and mouthpiece of the pipe. Keep in mind that the resin will stain most anything it comes in contact with, so exercise caution and have a paper towel or similar in place to wipe off the collected resin. Of course, if you want to save the resin for smoking later, you can collect it all in a non-reactive glass or plastic vessel of some kind.
Step 3: Break out the freezer baggie! Place the pipe in the bag with a good scoop (we recommend a tablespoon or two) of salt, then enough rubbing alcohol to submerge the pipe completely. Sealing up the baggie, start gently swishing and rubbing with your fingers to scrub the pipe with the salt-and-alcohol mixture. Keep this up for a good minute or two (you may want to employ a timer if cannabis has altered your perception of time), then allow the pipe to sit in the liquid for a couple of hours. Repeat the gentle scrub if you feel it’s needed.
Step 4: Once the scrub is complete, rinse the pipe thoroughly in hot water, gently dry with a towel of some sort, and inspect. At this point, you may want to use the pipe cleaner to remove any stubborn traces of resin and restore some of the pipe’s original shine. If you haven’t gone too long between cleanings, your pipe should be shiny and ready for further use!
How to Clean Glass Pipe Without Alcohol
Although we feel it’s a safe household solvent when thoroughly rinsed, some people prefer to avoid isopropyl alcohol altogether.
An alternative cleaning regimen is to boil enough tap water to cover the pipe by a few inches in a saucepan, reduce the heat to a simmer, and submerge the pipe for half an hour or so. Be sure that the simmer is low enough to release gentle bubbles, but not evaporate off and leave the pipe uncovered, which could crack it. After the time has elapsed, carefully drain the water and—exercising extreme caution as the pipe will be hot—clean and dry it thoroughly with a towel and/or pipe cleaner.
Georgie25
I got some crack i want to smoke soon but no access to the typical crackpipe. How else can I smoke this effectively?
——
Prismed
You can make pipe out of tinfoil and put some ash on the bottom and then put the rocks on top
Or you can make a pipe out of an aluminum can and do the same thing
Happy Smoking 🙂
lyrrad85z
tin foil gets too hot, plus cans are more plentiful, use a can but dont make the holes too big.
Prismed
If you use a can make sure to put a carb on the side
You’ll get some monster hits smoking it this way
Georgie25
I dont understand, I wanna do the can method but where do I get ash from? And do I just get a can and put a dent in it and poke holes n put the crack on the hole and light up? Some of the peices in this bag i have are pretty small might fall in? Any step by step instructions for making 1?
Thanks 🙂
3DayRun
don’t forget that you can use a lightbulb, too!
lyrrad85z
dent the top. scratch off the silk-screened label, about the size of a quarter in the dent. poke tiny holes, about 8-10 where you scratched. poke a hole in the bottom of the can, or the side for a carb. get the ash from a cig. let it burn and flick it right on your holes. gently, GENTLY, pack the ash and place your butter on top. hit that shit hard with the flame on the whole time and hold it till you cain’t no more.
Georgie25
How do I use a lightbulb? Same way as vaping weed? Or do i not “vape it”?
Georgie25
I dont have any cigs or weed etc, do I NEED the ash?
3DayRun
Yeah, you’re basically vaping it. Same way as tweak or weed.
ech0s85
people smoke weed from lightbulbs? Ive hit crack out of a regular pipe before it had a tiny hole so it didnt run through right away but even after it did we just sucked the flame into the bowl and got bomb hits.
Heighton720
cans are a good way.you can get HUGE hits this way BUT it also wastes some of the rock.but i likeusing cans when i have nothing else lol
Nib
I dont have any cigs or weed etc, do I NEED the ash?
There’s a lot of other material that creates ash when burnt.
Pegasus
Yeah, you’ll need some ash if doing it this way…
As an aside, how does a light bulb work? I would think you’d need a lot bigger flame? Meth, I could see, cause it doesn’t need much flame. Crack, though?
memphiseve
You can use the handy dandy tire gauge.
Just take off the end, everything will come out, pack with chore and bam
http://www.scooterunderground.ca/products/accessories/images/tire_gauge.jpg
OpiYum
Or got to hardware store and get tubing cut to size and filters from under the sink.
Herbal~Jah
what about tin foil? Can’t you smoke crack off tin-foil like they do with Heroin??
,290000000,4,null,null,'4','the mason channel',null,null,2,null,null,null,'Terrell',null,2,null,null,null,'my rating to 1 star. Episode choose your story for mac. The game itself is great, if you are willing to spend money on every story.
Pegasus
^You need a good amount of heat for crack, I don’t think tin foil is a good choice…
BrokedownPalace
If you are able to score crack, surely the person who sold it to you can tell of of a store that sells glass “rose” stems. they cost like 75 cents and come with chore boy. In the hood they sell them at basically every convenience store/bodega. Just ask for a glass rose and chore boy. Chore boy is just brillo pad basically that you use as a screen in the tube. Also in a pinch I suppose you could use a weed pipe with a metal screen (or chore boy).
With smoking crack you want to kinda melt the rock into the chore boy, and then hit that. Free base cocaine is kinda a runny liquid almost so melting it into the chore prevents it from just dripping down the pipe. After you are done smoking, push the chore back and forth through the stem to collect the resin, and you’ll get a BOMB couple of hits of ‘push’.
Can You Smoke Crack With A Glass Pipe? - Quora
Now you’re making me want to go buy some rocks.
Asyd420
^ thinkin the same thing. about getting some rocks.
knightlinger
If you are using a can, after you are finished smoking, cut your can open carefully so as not to disturb the areas where your holes were. Look inside around the small holes where your rock dripped through and you should see some product that dripped through and collected around the holes. This will be your purest coke and you can prepare another can and have some hellacious hits from this retrieved product. If using a glass or metal stem after smoking, remove the choreboy , take regular “not menthol” rubbing alcohol and pour a little into one end of the stem/pipe being careful to plug the opposite end of the stem with a finger. Then cover both ends of the stem with your fingers amd shake the alcohol inside the stem vigorously. Pour the alcohol on a clean flat dinner plate, carefully light the alcohol afire with your lighter and let the flames burn off the alcohol. When fire goes out, if plate is still wet, then let the plate dry off in front of a fan if necessary. Once completely dry, take a rasorblade and scrape the tan/ brown dried product into a pile and get ready to smoke it. It holds one hell of a punch. It may taste a little like alcohol so that is why I say don’t use the menthol scented alcohol as it will taste nasty! Trust me that these retrieval methods work when you are out of product and need one or two last hits!
Psychedelic Jay
Crack works just fine off foil.
I personally use the foil spoon and straw method…
Fashion a square piece of foil around the tip of you finger and smash half of it to a stem. Take a bic pen body and drop your rock in the little spoon you made and vape from underneath and suck up through the straw.
Answered - - How To Smoke Crack And Not Waste It | Drugs-Forum
It’s basically = the same principal as smoking heroin, but it is a lot more resistant to heat which make the margin of error a lot wider for you.
lazerlight
can u go more detail?
Seasonaltoker411
I know this is an old post, but came in handy very much. Those who stated the can trick is the best alternative are absolutely correct. I’ve only smoked hard a couple times so has no reason to purchase the works, and this technique works wonders. As long as you make your holes small enough and cover them with cig ash, you get huge rips. As stated above(or below?) don’t forget to poke a hole in the side of can for a shotgun, as you would if you were smoking a bowl. Don’t bother trying to make a tin foil pipe, waste of product and you’ll prob burn yourself, using foil for free basing is a different story, but I would still prefer the can method
tunesey
get yourself a small water bottle and make a small hole in the side big enough for a bic pen to go into discard the ink cartridge put tinfoil over the part of the bottle you drink out of put lots of holes in the tin foil and fill it with cigarette ash place your crack on top and happy smoking easy as 123